Assembled in the USA by SES

6mph with 5 and 7 blade.

Uses: Battery or battery bank charging, stackable wind turbine grid tie inverters, direct DC water heating elements, direct DC resistive heating, or other applications where 3 phase AC or DC can be used.

What you get with the 500 Watt Wind Turbine:

• 5 or 7 Raptor Generation 4 Wind Turbine Blades for maximum output
• Assembled blades are 60″ diameter
• Blades do not overload the PMA at low RPMs, turns faster for more amps
• Wind Turbine Blade Hub
• 3/16” thick steel, no cheap aluminum or plastic
• Zinc Plated or Powder Coated
• 500 Watt Permanent Magnet Alternator
• Standard 17 mm shaft
• 100% solid core zinc plated rotor design with air flow holes for cooler operation
• Smoother operation with flywheel power boost
• Housing bolts treated with anti-seize to prevent dissimilar metal corrosion
• Above 500 watts if you have zone 2 winds or above; power rated when using Raptor G4 blades. Easy start-up in zone 2 winds or higher depending on blade set.
• 125,000 hours+ of rated bearing life. New bearings cost only $5.00
• AC Output Models: The 3 phase AC to DC bridge rectifier can be installed next to your batteries or inverter for a 3 phase cable run down the tower.
• DC Output Models: The 3 phase AC to DC bridge rectifier is built into the case making it a two wire run to your charge controller or batteries.
• Tail Fin & Arms
  • 16 gauge powder coated steel
  • Measures 13 x 19 Inches
  • Double tail arms
  • Steel mounting bracket
  • Fits on 1.5″ schedule #40 or #80 pipe
  • Powder coated
• Limited Warranty